GSM/GPRS Communicator. The BGSM-G gives total confidence in all security and surveillance applications and is the ideal way of completing whatever system . (see instructions), and then close the B-GSM. + Screw the 3[G]. In the event of GSM network signal fail- ure a signal as per figure 3b will be present on terminal . The BGSM-G-EU is Bentel’s all new universal global system mobile (GSM) alarm communicator is a versatile device that accommodates end-users that are not.
|Published (Last):||8 November 2006|
|PDF File Size:||6.82 Mb|
|ePub File Size:||14.15 Mb|
|Price:||Free* [*Free Regsitration Required]|
Enhancing home automation with IoT OctoberElvey Security TechnologiesProducts, Integrated Solutions By automating elements which are electronically driven, homeowners are given the power to improve their quality of life by implementing these enabling technologies and controlling them via a smart device.
BGSM-G Universal Alarm
This Device must be installed indoors in a non-hazardous location. Using anchor screws not includedmount the cabinet to the wall.
Check for cable bggsm-g and water pipes before drilling. The details submitted in this form will not be shared with any third parties. Description This Device manages SMS and Central Station transmissions and can simulate the land line in the event of trouble land line down or even substitute the land line completely in areas where the GSM service is provided and where the land line is not available.
BGSM-G Universal Alarm
Reattach the front cover  securely to the cabinet. The performance of this Device depends greatly on GSM Network coverage, therefore, it should not be mounted without first performing placement tests to determine the best location for reception minimun one green LED is ON.
It can effectively monitor optical lengths of up to km per controller for buried, and 80 km for fence installations. Remove the screw and the front cover . There is also an account supervision feature that sends out information maunal IP in the event of a communication failure.
The SMS dialler function manages mnual numbers and sends trouble alert, periodic transmissions and pay-as-you-go balance messages. Before inserting or removing the SIM card, please ensure the unit is powered down. Using the connector , connect the GSM Module . Lay the cables, then pull them through the cable entry .
The content of this article Fit the antenna  ensure that the bolt  is fastened tightly. This Device has 4 Outputs which can be set up from remote locations or used for status signalling.
This Week’s Editor’s Pick. The communicator connects the alarm control panel to the GSM network to report alarm signals directly to the monitoring station receiver, and is compatible with any control panel that communicates using the Contact ID format. Route wires as indicated in Figure 1. Complete the connections on the terminal board .
The communicator is protected against tampering and provides tamper signals on two terminals, while the device can also be programmed and controlled via a PC manjal application which is available as an accessory. Your name Your email address Their name Their email address Your message The details submitted in this form will not be shared with any third parties.
Using the cabinet, mark the 4 screw locations then drill the anchor screw holes. If both are ON, it indicates perfect coverage. It has home remote automation capabilities and a full event report program. This Device should be located in a safe dry place away from radio transmitters and similar devices.
More information about Elvey Security Technologies.